corners

Step-by-step instructions to gluing inner corners

After completing, the main problem can be irregular walls and the resulting springs on the background. It is also necessary to take into consideration that when the walls are crooked, the joints of background canvases may diverge.

After gluing the previous one in front of the inner corner of the cloth should measure the remaining distance. It’s measured from the border of the glued cloth to the adjoining wall, and the resulting figure is inserted 10-15 millimeters. When the partitions are very curved, the extra figure may be more.

Cut a strip equivalent to the resulting figure, taking into account the allowance. The surfaces are treated with glue. Based on the type of coating it could be precisely the wall or both surfaces.

The strip is glued individually using the cut side into the wall. The wallpaper should go on the other airplane.

If the glued background is wrinkled, you have to make a few little cuts perpendicular to the folds.

Level or incline on the adjoining wall is a perpendicular line. The distance in the corner is equivalent to the diameter of the preceding cut strip, not including additions.

The surfaces are smeared with adhesive, and then the coat is glued into the wall with the flat side towards the marked line. gidpola.ru The cut goes onto the adjacent wall.

Protruding corner should be glued by analogy with an inner, however there are little gaps, which also need to be taken into account when working.

Measured the space remaining out of the glued background to the adjacent wall. Insert 20-25 millimeters to the obtained figure.

A segment is cut off, taking into account the added 20-25 millimeters.

Before gluing, the surfaces have been treated with adhesive.

The edge has to be glued to the wallpaper fixed on the walls, your own cut side”goes” into the adjacent plane. If needed, small cuts are created in the area of going to another background, smoothed and pushed into the wall.

Draw a vertical strip on the adjacent wall in a distance of just glued cut strip and 6-10 millimeters.

After applying the adhesive, the strip is placed on the wall with its flat side towards the line, going over the border of this already glued strip.

The joints are smeared with glue and ironed using a roller. After that, the top layer is trimmed across the ruler and the 2 layers are joined together.